A couple of things...
Accidentally did a [Quick Run] and after that it continued to launch a CMD and run the program even though I was doing a [Rebuild All] or [Compile] - even after exiting WinFBE and restarting it.
I don't remember what it was in the WinFBE.ini file - but when I diff'd it with a saved version, there was something different in the [Builds] section. So I just overwrote with my saved INI file and the regular compiles were good again.
I also had a WinFBE issue that required a process kill to exit. This error has happened a couple of times. I *think* my steps were:
- * Had a project opened with its files.
* Did a [File Open] on file "X" that I just wanted to compare to a file in the project... I did NOT do a [Project][Add files to Project].
* Made some changes to some of the project's files - [Ctrl-S]'d them as I went along.
* Made some changes to file "X" - [Ctrl-S]'d it as I went along.
* Occasionally did a [Project][Save Project].
* Closed file "X".
* Made some changes to some of the project's files - [Ctrl-S]'d them as I went along.
* Tried to do a [Project][Save Project].
* Error dialog:
.. File Changed:
.... File "X"
.... This document has been deleted or is no longer available. Do you wish to keep the file open in the editor?
* Clicked on [No].
* Kept getting error dialog...
* Tried clicking [Yes] - tried clicking [No].
* Kept getting error dialog...
* Any click on WinFBE gave the error dialog again.
* Killed WinFBE process.
* Launched WinFBE.
* Opened project.
* ... Back to the error dialog.
* Killed WinFBE process.
* Deleted "myproject.wfbe" file.
* Recreated project and everything was good again.